Osburn 2500 Pellet Stove

The new Osburn 2500 pellet stove is an entry-level appliance, roughly comparable to the 3000 model, whose appearance is more like that of a conventional wood stove. Although slightly different in some respects than its congener, it still retains the same distinctive signs of the brand.

This pellet stove is made from high-quality materials: Canadian steel of a higher grade, glass ceramic imported from Germany, heat exchangers made of stainless steel and thermosetting powder paint. Despite these real assets, worthy of a remarkable design, this product is offered at a very competitive price in addition to being eligible for certain credits and programs (government incentives).

Responding largely to the next highest standards of solid fuels and environmental protection, the Osburn 2500 has an incredibly low average of particles emission rate below 0.96 g/h.

Thanks to easy installation, intuitive electronic control and easy to use thermostatic control, the Osburn 2500 is for anyone who wants nothing complicated. It is also easy to clean with access to removable components without tools.

Specifications

Appliance Performance

⁽¹⁾ Values are based on test methods, except for recommended heating area, firebox volume, maximum burn time, and heat output.

⁽⁾ Recommended heating area and burn time may vary depending on location, chimney draft, climate, fuel type, and other factors. The heating area is defined by the manufacturer’s capacity to maintain a minimum temperature during power failure.

⁽²⁾ Maximum heat output (dry cordwood) is based on a loading density of 15-20 lb/ft³ and reloading intervals of 60-120 minutes. Other performance data assumes a fuel load of 7-12 lb/ft³ with 19-25% moisture content.

⁽³⁾ As measured per CSA B415.1-10 stack loss method.

⁽⁴⁾ Higher Heating Value of the fuel.

⁽⁵⁾ Lower Heating Value of the fuel.

⁽⁶⁾ Performance based on prescribed fuel load (7 lb/ft³, 19-25% moisture content).

⁽⁷⁾ Optimum overall efficiency at a specific burn rate (LHV).

⁽⁸⁾ Efficiency is optimized at a specific burn rate (LHV) and reflects the appliance's heat transfer efficiency at low burn rates.

⁽⁹⁾ This appliance is tested and certified by an independent agency.

⁽¹⁰⁾ Carbon monoxyde.

⁽¹³⁾ Unless stated otherwise, measures were taken directly at the main power source and include all electrical components present in the appliance.

General Features