Osburn Stratford II Wood Fireplace

Let yourself be charmed by the timeless beauty of this non-catalytic wood fireplace, which performs particularly well and meets the EPA's most restrictive emissions standards.

The Stratford II offers you more, including a 2.5 cubic foot firebox that’s easy to access through double-cast iron doors. This unit will impress you with its distinctive style and exceptional heating capacity. 

Specifications

Appliance Performance

⁽¹⁾ Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.

⁽⁾ Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.

⁽²⁾ The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.

⁽¹⁾ Values are based on test methods, except for recommended heating area, firebox volume, maximum burn time, and heat output.

⁽⁾ Recommended heating area and burn time may vary depending on location, chimney draft, climate, fuel type, and other factors. The heating area is defined by the manufacturer’s capacity to maintain a minimum temperature during power failure.

⁽²⁾ Maximum heat output (dry cordwood) is based on a loading density of 15-20 lb/ft³ and reloading intervals of 60-120 minutes. Other performance data assumes a fuel load of 7-12 lb/ft³ with 19-25% moisture content.

⁽³⁾ As measured per CSA B415.1-10 stack loss method.

⁽⁴⁾ Higher Heating Value of the fuel.

⁽⁵⁾ Lower Heating Value of the fuel.

⁽⁶⁾ Performance based on prescribed fuel load (7 lb/ft³, 19-25% moisture content).

⁽⁷⁾ Optimum overall efficiency at a specific burn rate (LHV).

⁽⁸⁾ Efficiency is optimized at a specific burn rate (LHV) and reflects the appliance's heat transfer efficiency at low burn rates.

⁽⁹⁾ This appliance is tested and certified by an independent agency.

⁽¹⁰⁾ Carbon monoxyde.

General Features